The Classica Outdoor Wall Lantern is a contemporary take on a classic design. Made from stainless steel, including external screws, this outdoor wall light is rust resistant, designed to last and really looks the part. The Classica Wall Light has four glass faces, each edged with a stainless steel trim, and a decorative mounting plate. Changing the lamp is easy with four simple dome nuts holding on the shade. Unlike many other models, the screws are fixed in place which means they cannot be dropped and lost, and there is no need for tools - simple yet effective!
Both Photocell (dusk to dawn) and PIR (motion sensor) versions of the Classica are also available. Codes LLSS181 and LLSS182
The colour of a lamp is defined as a measurement called kelvins. A standard GLS incandescent bulb in the home would be 2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white spectrum.
Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have an IP rating appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation. The weakest point is always cable joints. All joints must be made 100% watertight and this can be done using IP68 cable connectors and/or waterproof junction boxes which are then filled with a re-enterable liquid gel mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay-based soil areas. If possible, use ground surface spike lights rather than a buried light. Mains 240v cable will have less joints than a low voltage installation but care must be taken with the cable runs. Cabling should be Rubber Butyl and not PVC. PVC leads to capillary action over time especially with UV degradation.
All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with
Part P certification. There are a selection of waterproof jointing kits and boxes available on this web site.
|IP rating:||IP 44|
|Finish:||304 Stainless Steel|
|Material Finish:||stainless steel 304 and glass|