The Classica Outdoor Wall Light with PIR Motion Sensor is a contemporary take on a classic style. Made from stainless steel, including external screws, this outdoor wall light is rust resistant, designed to last and really looks the part. This stylish wall light adds security to any outdoor space, with the built in PIR Motion Sensor automatically switching on the lantern when movement is detected. PIR motion sensor wall lights are the perfect way to reduce wasted energy and save money, only turning on when light is required by the passer by. An in-built photocell also ensures that the Classica PIR is not triggered during the day unnecessarily. The amount of time the lantern remains illuminated and how dark it must be before the motion sensor kicks into action is also adjustable. Ideal for when houses are left unoccupied as any potential intruders would cause the light to turn on, exposing them in the darkness and resulting in them fleeing the area.
The colour of a lamp is defined as a measurement called kelvins. A standard GLS incandescent bulb in the home would be 2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white spectrum.
Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have an IP rating appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation. The weakest point is always cable joints. All joints must be made 100% watertight and this can be done using IP68 cable connectors and/or waterproof junction boxes which are then filled with a re-enterable liquid gel mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay-based soil areas. If possible, use ground surface spike lights rather than a buried light. Mains 240v cable will have less joints than a low voltage installation but care must be taken with the cable runs. Cabling should be Rubber Butyl and not PVC. PVC leads to capillary action over time especially with UV degradation.
All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with Part P certification. There are a selection of waterproof jointing kits and boxes available on this web site.
|IP rating:||IP 44|
|Finish:||304 Stainless Steel|
|Material Finish:||stainless steel 304 and glass|