01689 606342

Tango Tall bollard, 800mm height IP44, 9.2W LED bulb (not supplied) 304 stainless steel

The Tango range of exterior lights has a modern design providing the perfect complement to any outdoor space. When planning your exterior lighting design it is nice to have consistency and a uniformed approach to your design. The Tango tall is one of 3 products in the Tango range. The tallest  is a 800 mm high floor mounted stainless steel bollard with integral anti glare louvre which is designed to punch the light down on to the pathway or drive way entrance, Because of the design light pollution is kept to a minimum and light is only directed to where it is needed most. There is also a shorter bollard at 450mm and a wall light to compliment the range. All can be used with an Eco friendly energy efficient LED bulb. The fittings are easy to clean and have an IP44 weather protection.

There are E27 base LED lamps available which can be used in this light fitting but up to a maximum wattage of 9.2w 

Bollard types and spacing


Bollard lights are available in a variety of styles, finish and lamp options. You need to think about how the light will be used for example a small garden pathway, the main driveway or to illuminate steps etc.  If you are within 20 km of the coast you should think about using the Wooden, Copper, Iron, Brass or Marine Grade 316 Stainless Steel. Some bollards have built in LED modules which generally offer lower levels of light (lumens) than a standard LED GU10 lamp. Also, it is likely the LED module is a sealed unit and an integral part of the bollard which cannot be replaced if it fails meaning you will have to purchase a complete new bollard. There are bollards that use GU10 LED lamps and E27 base LED lamps. The spacing of bollards will depend on the type of bollard, louvre design, height and lamp output etc but a general rule of thumb would be no less than 3 meters and no more than 12 meters apart. The shorter distance would be for garden pathways and the longer distance for long driveways.


Lamp colour ( Kelvins )


The colour of a lamp is defined as a measurement called kelvins. A standard GLS incandescent bulb in the home would be 2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white spectrum.

Installation 220 – 240v

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have an IP rating appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation. The weakest point is always cable joints. All joints must be made 100% watertight and this can be done using IP68 cable connectors and/or waterproof junction boxes which are then filled with a re-enterable liquid gel mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay-based soil areas. If possible, use ground surface spike lights rather than a buried light.  Mains 240v cable will have less joints than a low voltage installation but care must be taken with the cable runs. Cabling should be Rubber Butyl and not PVC. PVC leads to capillary action over time especially with UV degradation.

All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with Part P certification. There are a selection of waterproof jointing kits and boxes available on this web site.

Item Specifications

colour: stainless steel 304
Voltage: 220 - 240v
Max wattage: 9.2w
IP rating: IP 44
Height: 800mm, 450mm
Dimensions: 450mm height x 140mm diameter
Material Finish: Stainless Steel 304
Bulb Type: E27
Warranty: 2 Years