01689 606342

 Bianco - 240v - 304 - Brushed Stainless Steel IP44 E27 - Wall Light - Also Available With PIR


Designed to last, the Bianco fittings have a durable stainless steel front and a vandal resistant polycarbonate casing, so you can be sure that they won't be easily damaged. Very contemporary curved flush design which would suit most modern households.

Modern, brushed 304 stainless steel exterior wall bracket with an opal diffuser made from polycarbonate. This fitting is compatible with energy saving lamps and is IP44 rated.

Suitable for indoor or outdoor use with LED E27 base lamps.

There is also a  PIR version available to match with this product to keep a consistent design theme to your outdoor lighting. Code number ST031FPIR.

Lamp colour ( Kelvins )

Lamp colour is determined by the Kelvins and a lamp which is  2700 kelvin  is classed as warm white and sympathetic to skin tones and warm brickwork. A kelvin of 6500k is in the  blueish white spectrum and works well against a white background and will appear brighter to the naked eye than the warm colour spectrum.

Installation 

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have a IP rating which is explained further in our design ideas section but in simple terms the IP rating is appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation as the weakest point is always cable and transformer joints. All joint must be made 100% water tight and this can be done using heat shrink kits, waterproof junction boxes which are then filled with a resin mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay based soil areas. If possible use ground surface spike lights rather than a buried light.  Mains 240v cable will have less joint than a low voltage installation but care must be taken with the cable runs.     

     

Item Specifications

colour: stainless steel 304
Weight: 1.2kg
Voltage: 240V
Max wattage: 60 w
IP rating: IP 44
Width: 216mm
Height: 300mm
Dimmable: Non-dimmable
Sensor: PIR, None
Sensor_Description: 100 degree detection angle
Material Finish: Brushed stainless steel & opal pc
Bulb Type: E27
Projection: 92mm
additional information: Complete with fixing accessories
Warranty: 2 Years