01689 606342

     

Bliss - 240v - 304 Brushed Stainless Steel IP44 E27 Max 10.5w Wall Light - Lantern Light


The Bliss wall light is an attractive and modern style fitting and has a delicate contemporary look, with a 304 brushed stainless steel finish that will enhance the appearance of any premises. There is also two Bliss Bollard path lights codes 92531 and 13799 which would compliment the pathway. The bollards and the wall light have been designed to keep lamp glare to a minimum and therefore reduce the impact of light pollution in the area, The louvre system pushes the light down where it is needed most. The stainless steel finish also makes it easy to clean. Each light fitting can be used with an LED screw threaded E27 candle style lamp.

The Brushed stainless steel finish is not recommended by coastal or marine areas within 20 miles of the coast.

Lamp colour ( Kelvins )
 

The colour of a lamp is defined as a measurement called kelvins. A standard GLS incandescent bulb in the home would be 2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white spectrum.

                                                                 Installation 220 – 240v

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have an IP rating appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation. The weakest point is always cable joints. All joints must be made 100% watertight and this can be done using IP68 cable connectors and/or waterproof junction boxes which are then filled with a re-enterable liquid gel mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay-based soil areas. If possible, use ground surface spike lights rather than a buried light.  Mains 240v cable will have less joints than a low voltage installation but care must be taken with the cable runs. Cabling should be Rubber Butyl and not PVC. PVC leads to capillary action over time especially with UV degradation.

All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with Part P certification. There are a selection of waterproof jointing kits and boxes available on this web site.               


Item Specifications

Colour: Silver
Weight: 0.7kg
Voltage: 240v
Max wattage: 10.5w
IP Rating: IP44
Materials: Stainless Steel
Bulb Type: E27
Warranty: 2 Years