01689 606342

KINI EL TRIAC - Tilt - Recessed soffit light IP65 - 220-240v 12w white


The dimmable KINI recessed ceiling light impresses with its simple appearance. Rated IP65 it can be used outdoors or in damp areas. It is available in white with a round shape. Equipped with a powerful, warm white LED in a swivelling mount, and the LED  driver included in the scope of supply, the set can be used in any lighting situation. The electrical connection is made directly to the 230V mains supply.

The fitting has an integral 3000k warm white sealed LED chip giving out 850 lumens and this factory built LED  can be replaced by returning the fitting to our manufacturer or by a service technician authorised by them. The lamp life is approximately 30,000 hours. 

The fitting has a 30 degree tilt range and a 60 degree beam angle. The fitting has an integral dimmable triac driver and can be connected to a 220- 240v power supply.

The LED chip uses 12w and the fitting is a white powder coated aluminium fitting with a polycarbonate lens.  Ideal for outdoor soffit spaces and eves with sloping roofs.

Cut out 90mm. Overall diameter 108mm and depth 65mm.

Lamp colour ( Kelvins )

 

The colour of a lamp is defined as a measurement called kelvins. A standard GLS incandescent bulb in the home would be 2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white spectrum.

Installation 220 – 240v

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have an IP rating appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation. The weakest point is always cable joints. All joints must be made 100% watertight and this can be done using IP68 cable connectors and/or waterproof junction boxes which are then filled with a re-enterable liquid gel mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay-based soil areas. If possible, use ground surface spike lights rather than a buried light.  Mains 240v cable will have less joints than a low voltage installation but care must be taken with the cable runs. Cabling should be Rubber Butyl and not PVC. PVC leads to capillary action over time especially with UV degradation.

All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with Part P certification. There are a selection of waterproof jointing kits and boxes available on this web site.


Item Specifications

Beam Angle: 60 degree
colour: white
Cut out: 90mm
Voltage: 220 - 240v
IP rating: IP 65
Height: 65mm
Degree of tilt: 30 degrees
Lumens: 850 lm
Material Finish: Aluminium
Bulb Type: integral LED
diameter: 108mm
watts: 12w
colour temperature: 3000k Warm White
Warranty: 2 Years