This product is out of stock. Please call the office.
The Halbury is a practical yet stylish wall light. Suitable for outdoor use and with a Matt Black finish it offers a traditional lantern look. This integral 7w cool white LED version giving out 500 lumens also has PIR technology so is activated by movement, making it ideal for pathways and doorways and as extra security. Also available in Matt White code number 54554
The colour of a lamp is defined as a measurement called kelvins. A standard GLS light bulb in your house would be 2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white spectrum. Getting the right colour temperature of a lamp does matter as the warm colour wavelength helps to soften the tone of the area and gives a warm soft relaxed feel and ideal for colourful flower beds and rockery areas especially with wooden bark and at the other end of the scale a 4,000 to 5,000 kelvin lamp colour would be used against a light background such as white walls or to accentuate grey blueish foliage in shrubs and small trees. When you buy a new, energy efficient bulb, keep your application and colour scheme in mind and make sure to buy the bulb with a colour temperature to match.
Existing fittings must be completely removed before installation of a new product. Before removing the existing fitting, carefully note the position of each set of wires.
• The help of an assistant is recommended when installing this fitting.
• Remove 6 securing screws to separate shade from the wall back. PIR sensor connection cable can be disconnected to make the installation easier (see Fig.1).
• Using the wall back as a template, mark the position of the mounting holes. Drill holes and fit supplied wall plugs (suitable for masonry only - for other surfaces use appropriate fixings). Feed the incoming mains supply cable through the grommet entry hole. Fix the wall back to the wall using the supplied screws (See Fig. 2).
This product is double insulated and must not be earthed. If there are any incoming earth cables, they must be joined together and well insulated with good quality insulation tape. This is to ensure earth continuity throughout your property. Remove the cover from the mains terminals and having correctly identified the wiring from your existing light fitting, connect to the quick fit connection block.
Refit the shade, Reconnect PIR sensor cable if necessary. Replace fuse or circuit breaker and switch on. Your light is now ready for use.
Make sure the fitting is correctly oriented in a vertical position and fitted 1.8m - 2.5m above the ground.
The PIR sensor can be adjusted using the LUX and TIME screws, allowing the detection distance to be altered to suit
The detection angle is set at 130 degrees and the detection distance is 8m. The PIR will start activating when the light level drops to 20 LUX and will continue to activate until the light level rises to 2000 LUX. When adjusting the sensitivity (detection distance) in daylight it will be necessary to cover the sensor to simulate night time. When the PIR is activated the light will remain lit for a maximum of 5 minutes. The minimum is 5 seconds.
The LED bulb in this product are non replaceable.
|IP rating:||IP 44|
|Technical:||Complete with LED driver|
|Sensor_Description:||20 lux on, 2000 lux off. 130° detection angle, 8m maximum range with a 5 second to 5 min timer function|
|Material Finish:||Matt black textured & frosted pc|
|Bulb Type:||integral LED|
|colour temperature:||4200 Cool White|
|additional information:||Complete with fixing accessories|