01689 606342

Pema, exterior grey - surface LED wall light, Mains 240v, 4.7w, warm white, 3,000 kelvin, 125 lumens, IP44

The Pema comes in three colour finishes. Code 231012 Silver Grey with 125 lumens, Code 231015 Anthracite with 125 lumens and code 231010 white with 125 lumens.  Not suitable for coastal areas.
A very modern contemporary styled small yet powerful 4.7w LED puck light. Total consumption 4.7w. Ideal for low level illumination or on a wall to illuminate a house number or steps. A clean simple design with a very low energy consumption. Water resistant IP44. Very low glare rating due to the recessed lamp and shield from the luminaire housing.  

LED luminaires run very cool and therefore safe to touch, they also use very low power consumption to save on electricity bills and also have a long life span. And if you use a mains 240v  LED luminaire there will be no need for a transformer which can sometimes be awkward to hide.       

One disadvantage to using a mains 240v luminaire rather than a low voltage one is when the luminaires fails you will have to throw the whole fitting in the bin and buy a new one and if they no longer sell that product you will need to replace all the units. Another disadvantage to using mains 240v in the garden is the danger of cutting through the cable. A 12v supply is a lot safer for exterior installations.

A guide to lighting steps


Lamp colour ( Kelvins )


The colour of a lamp is defined as a measurement called kelvins. A standard GLS incandescent bulb in the home would be 2,700 kelvins which is in the warm colour spectrum and a lamp with 5,000 kelvins would be at the very cold white spectrum. 

Installation 220 – 240v

Choosing the style of a product is only part of the equation you must also think of where that product will be used and how it will be installed. All exterior lighting products on our web site have an IP rating appropriate to each light fitting and its intended application and is therefore fit for purpose. Water ingress is the enemy for outdoor lighting and the products supplied are only as good as the installation. The weakest point is always cable joints. All joints must be made 100% watertight and this can be done using IP68 cable connectors and/or waterproof junction boxes which are then filled with a re-enterable liquid gel mix. All joints where possible should be made above ground for easy access and reduced water ingress. When installing ground buried lights adequate drainage systems should be put in place especially in clay-based soil areas. If possible, use ground surface spike lights rather than a buried light.  Mains 240v cable will have less joints than a low voltage installation but care must be taken with the cable runs. Cabling should be Rubber Butyl and not PVC. PVC leads to capillary action over time especially with UV degradation.

All exterior lights must be installed by a certified NIC EIC electrician and should be signed off by an electrician with Part P certification. There are a selection of waterproof jointing kits and boxes available on this web site.

Item Specifications

Colour: White, Anthracite, Grey
Weight: 0.3kg
Voltage: 240v
IP Rating: IP44
Materials: Aluminium
Depth: 4.2cm
Lumens: 125 lm
Bulb Type: Integral LED
diameter: 9cm
Colour Temperature: 3000K
Warranty: 2 Years
Watts: 4.7W